Iphone 4 CDMA 6.0.1 (no 3g)

**rich hathaway** · 11-27-2012, 04:55 PM

for the text issue,it is because you must reboot tethered after you flash to make everything work,your text will work after that.

**cbernardo13** · 11-27-2012, 05:09 PM

I forgot, this us the iPhone forum... Sorry

Sent from my PG86100 using Tapatalk 2

**jgiv24** · 11-27-2012, 05:41 PM

Yeah I rebooted tethered after I flashed and I can txt just a lot don't get sent right away and I have to re-send over and over again until the message finally goes out. I have this problem a lot when txting other iPhones. I don't get any message, just message cannot be sent or message delivery failure. Also, I can't do any MMS either. Is this fixed yet Rich?

**jgiv24** · 11-27-2012, 06:43 PM

Originally Posted by jgiv24

Yeah I rebooted tethered after I flashed and I can txt just a lot don't get sent right away and I have to re-send over and over again until the message finally goes out. I have this problem a lot when txting other iPhones. I don't get any message, just message cannot be sent or message delivery failure. Also, I can't do any MMS either. Is this fixed yet Rich?

Also, I am on PRL 3026, do you think it would make a difference for the 3G or MMS if I went to PRL 3032?

**rich hathaway** · 11-27-2012, 06:53 PM

sounds like you didnt ota,do you show metro pcs on the top left of your phone?

**jgiv24** · 11-27-2012, 07:28 PM

Yes, it says MetroPCS, shows the o instead of 3G and if I go to Settings -> General -> About, it shows Network: MetroPCS, Carrier: Metro PCS 20.12. If I click that it shows PRL: 3026. I did OTA after I flashed it the first time, then re-wrote the PRL when you were helping me. Should I use the tool and write the 3032 PRL and then OTA, then re-write PRL? Also, could I have screwed something up in the Commcenter patching? I followed your instructions to a T and got no errors. Please let me know. Thanks.