Join Today













Site Sponsor
Results 1 to 5 of 5
  1. #1
    Newb
    Join Date
    Aug 2010
    Posts
    2
    Rep Power
    0

    Default Diagnostic Mode via Bluetooth

    So I broke my USB port on my HTC EVO 4G, but I need to get into my phone to update my settings to get my 3g working.

    I've been trying to connect Diagnostic Mode (##3424#) to QPST via bluetooth, but no luck

    So far, I can create a bluetooth connection to my windows 7 box, and associate it to a com port that is visible in QPST, but that's about it.

    QPST does not recognize the phone being in Diagnostic Mode via bluetooth.

    Do i need to install a specific driver? or is there a bluetooth diagnostic mode? Any ideas would help.

    Thank you in advance.

  2. #2
    BABY NEWB
    Mobile Files Advisor

    Join Date
    Jun 2010
    Posts
    57
    Rep Power
    146

    Default Re: Diagnostic Mode via Bluetooth

    You usually can not do diag through bluetooth. 1 reason is because QPST set's mode offline and reads back build information. When you offline the device it usually will turn off all radios, WIFI, Bluetooth, or place them in a mode to be serviced. Some older phones allowed it but most newer phones will disable bluetooth as well.

  3. #3
    ?LOST? whitey10tc's Avatar
    Join Date
    Jan 2010
    Location
    Sandy, Utah, United States
    Age
    50
    Posts
    1,701
    Rep Power
    880

    Default

    Not going to work on an evo, amos right.

  4. #4
    Newb
    Join Date
    Aug 2010
    Posts
    2
    Rep Power
    0

    Default Re: Diagnostic Mode via Bluetooth

    Ok, thanks guys for the quick reply. I will try and figure out how to solder the USB port back on the board instead.

  5. #5
    Android device Moderator Scuba's Avatar
    Join Date
    Nov 2010
    Location
    GA
    Posts
    203
    Rep Power
    133

    Default Re: Diagnostic Mode via Bluetooth

    Good luck Melonberry...Its not an easy task for sure...the contact points are below the port..Best way I found is heat up the actual connector and put in on the board real quick but straight.A hot air machine would do the job alot better im sure.


 

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •