Slow 3G after changes

[Ravenouschaos]

I had gotten an evo flashed to cricket and all services were working properly, but I was getting error 67 left and right, literally whenever i tried to use any service, it would still work, but this would pop up, so I changed my setting from:

Active Profile: 1
Username: [Only registered and activated users can see links. ]
SPI MN-HA: 4D2
SPI MN-AAA: 4D2
Reverse Tunnel Preffered: Enable
Home IP Adress: 0.0.0.0
Primary Home Agent: 255.255.255.255
Second Home Agent: 68.28.177.76
HA Shared Secret: ******
AAA Shared Secret: ******
DSA Server URL: [Only registered and activated users can see links. ]

MEID(HEX): A100000D9D7E4E
P_REV: IS-2000 (6)
SCM: 58
Slot Mode: Enable
Slot Cycle Index: 2
MCC: 310
MNC: 00
ACCOLC: 0
Vocoder: Enable
Roam Orig: Voice 13k
LBS PDE IP: <Not available>
LBS PDE Port: <Not available>
Home sys Reg: Enable
Foreign Sys Reg: Enable
Foreign NID Reg: Enable
DDTM: Disable
Home SID/NID #1: 5033/65535
MMS Server URL: [Only registered and activated users can see links. ]
RTSP Proxy Port: 554
RTSP Proxy Address: rtsp.vog.sprintpcs.com
HTTP PD Proxy Port: 8085
HTTP PD Proxy Address: pd.vog.sprintpcs.com

to

Active Profile:1
UserName:yourtendigitnumber@mycricket.com
Spi MN:HA: 12c
spi mn:AAA:2
Reverse Tunel:Enable
home IP:0.0.0.0
Primary Home:68.28.15.12
Second Home:68.28.31.12
HA Shared Secret:cricket
AAA shared cricket:cricket
DSA:Leave it as it is

Slot Cycle Index:
MCC:310
MNC:00
ACCOLC:2
Vocoder:Enable
EVRC-B: Disable
Home Orig:Voice 13k
Roam Orig:Voice 13k
LBS PDE IP: Blank
LBS PDE Port: BLANK
Home Sys Reg:enable
Foreign SID reg:enable
Foreign NID Reg: Enable
MMS Server URL: [Only registered and activated users can see links. ]
RTSP Proxy: 8080
RTSP Proxy Address: wap.mycricket.com
HTTP PD Proxy Port: 8080
HTTP PD Proxy Address: wap.mycricket.com


as recommended on this forum. Technically everything still works, as far as I can tell, but my internet and youtube etc have slowed to a crawl. Any advice is greatly appreciated. Thank you in advance.

EDIT: ALSO, STILL GETTING ERROR 67, AND NOW ALSO 131. Mostly when i activate the hotspot.

[Playa4Life352]

Are u on a proxy flash?

[rich hathaway]

error 67 is an error from sprint,i had a custy in here with the same prob. saturday,when the phone gets its 3g signal it is trying to connect to data services and uses the homepage @sprintpcs.com--- hence the user name and pass error 67 from sprint, so change your homepage to anything but sprint, and it wont keep trying to connect to sprint data services rejecting your user and pass throwing that error.( i changed to google for the homepage)

[Ravenouschaos]

Not sure what a proxy flash is, sorry, and my web page is set to google as well. After some closer observation the errors come up when I toggle mobile networks or wifi. Sometimes it is there when I go to unlock the phone, or when I bring up the android market. Some forums are saying this may be caused by a setting in the m.ip tab in QPTS. According to them it's because the authentification setting is set to simp+mob instead of just simp. I have qpst and the diag drivers, but does anyone know if I can edit just that setting without a full reflash? Since all services work i'd rather not mess that up, thanks for the responses.

[rich hathaway]

if your on the 60z plan you are not using a proxy,if your on the 45 dollar plan you are going thru a proxy to connect to the internet.
i have'nt used qpst to flash one because we have workshop,but i will tell you every one we have done we use mip+sip
if it were mine i would check the evdo tab w/workshop.
the updates sprint is sending is messing with alot of phones

[Ravenouschaos]

Ah, ok, no, then im not on a proxy flash. I heard the simp auth only applies to evos flashed to cricket. I will dl workshop and see what it says then get back to you, thanks.