Guide -- manual programming for ascend m860

[rich hathaway]

here is the manual programming code for ascend m860

[hide-thanks] dial ##626* then for the spc should be 333333-- some may be different,i have done about a dozen and all have been 3's[/hide-thanks]

[Jason Breedlove]

the 333333 does not work. is there another one?

[micmeezy]

The password to get into menu is 587843

[Jason Breedlove]

all 0's and all 3's does not work. is there another one i can do?

[rich hathaway]

ok,here is how to get the spc on the ascend- [hide-thanks]plug the phone and read it with workshop,if you dont have the ascend drivers use htc android drivers, then go to security tab in workshop and in the box for the 16 digit pass put ffffffffffffffff which is 16 f's,make sure that box is checked cuz by default the box on top is checked. then send the f's and walla you got yer spc,now dont forget to send the spc after it shows up,then write it to 000000.[/hide-thanks]

press thanks buttons to see the hidden content

[cancell]

Quick question with this:

When I send the 16 "f" code it said the code is correct and the phone is unlocked, but nothing shows up in the 6 digit SPC box. anything I might be doing wrong? Any tricks or places to look for incorrect settings?

Thanks guys!