you dont have to put it in dm mode to get spc,just plug the phone w/workshop select port read phone go to security tab and leave spc tab on default click read and that should give it to you, if you have older version before 3.5.5 on the same page(security) to the left where it says password,click "test" it will take 2 to 3 times to try all codes and after each try you will have to go back to the main tab and click disconnect and the reconnect and re-read then go back to security and try the send again to try the next group, it will automatically start where it left off as long as you dont close workshop and open it back up again.one of those 2 methods will work,but if you still have probs. i can get the spc for you for 7 bucks,only takes a minute or 2,but you can get it for this one yourself.