LG Dare Service Required

**thesmitty68521** · 03-19-2010, 08:33 PM

Yeah, that didn't work. It sucks. But I did notice that the phone got really hot when it was plugged in. So, I just gave it back to the customer. I've never had a problem like that before. I usually just reload the PRL and make sure the ESN isn't 0'd out.

**Woozy82** · 03-20-2010, 05:00 AM

Originally Posted by smitty68521

Yeah, that didn't work. It sucks. But I did notice that the phone got really hot when it was plugged in. So, I just gave it back to the customer. I've never had a problem like that before. I usually just reload the PRL and make sure the ESN isn't 0'd out.

should have checked for liquid or impact damage, liquid indicators can be misleading you may have a hardware problem that needed to be addressed before any software solution would work. I say this because you said phone gets hot

**jhepoi26** · 03-26-2010, 11:42 AM

I have the same problem too i even tried to hardware only few may passed but most of it failed...im still wondering if there any solution for it? It really get hot after you flashed it...

**rjq1125** · 07-03-2010, 04:14 AM

I have had the same problem, said service required. when I would press *228 it wouldnt even connect. But when I pressed *22804, it took me to a cricket operator. So after long hours I finally loaded the stock software and it worked again. I loaded it in lgnpst. After it was loaded I then used a cricket SCR, still with lgnpst. After that was loaded I went into CDMA WS and edited MIN / MDN / SID / NID , restarted it and it worked. Hope This Helps.