Quote Originally Posted by Help View Post
5. Open RSD General
(I didn’t worry about it saying does not support this phone or did not parse matrix file…)
Click on “provisioning”
Check on the boxes (left of the blue lettering) PRL, EVDO, Mobile IP, and RTT data
Click “Read Phone” (This may take 5-7 mins depending on your computer and the version of RSD General you are using.)
Click on “PRL” (maroon or blue lettering)
Click “Open File” and navigate to the .rla or .prl file you have chosen
Click on “EVDO”.
Enter [Only registered and activated users can see links. ] for all usernames and
cricket for all passwords.
Go to “Mobile IP” (click on the maroon or blue “Mobile IP”)
. For behavior select simple IP only
Initial Registration chose 1750
Registration Retries type 2
QC optimized dormant handoff checked
Mobile Node Authentication select RFC2002bis
MN_Authenticator enter 800100
DMU Public ID type 10
Network Access ID [Only registered and activated users can see links. ]
Reverse Tunneling checked

Now click on RTT Data
QNC chose Disabled
MDR select SO 33 (if available)
SCRM = yes
R_SCH = yes
Pocket = NO
Preferred chose RC3
Data…IS-707 SO
Primary DNS = 192.190.109.42
Secondary DNS = 192.190.109.43
Dial enter #777
PDC username [Only registered and activated users can see links. ]
PDC Password cricket
PAP/PPP all usernames and passwords are the same
MAKE SURE ALL IS CORECT BEFORE you write to phone
RSD General should tell you it was successful writing to the phone.
You should be able to OTA *228 or *22804 (if the phone has been activated)

If you still can’t make a call to OTA … then try this
Type ##073887* press green button like you are making a call
Enter 000000 for your security code (also called the SPC)
Click on “User Activation”
Click on “Nam1”
Edit your “MIN” (you found in step 1 g…usually not your phone number but 10 digits, and looks like a phone number)
Edit your “MDM” (your 10 digit phone number)
Now you should be able to talk and text

Last time i checked RSD General wont allow those settings to write to the fone on the MIP settings pages it says the values are not supported please correct me if im wrong but from what i have experienced flashing Q and Q9's thats what i get