This is a tutorial that is basically the same as Berry's from HOFO. Only, I made the snapshots all by myself. lol

These settings are pretty much the same for any handset that uses the LGNPST.

You will always need the DLL, LGNPST 1.1 (Lab Version), and a usb cable. If I have to tell you that you need the phone.....Well, then you probably shouldn't even have a phone.

This tutorial will assume you already wrote the PRL to the phone.



This part is self explanatory. Remember, look at the top of the screenshot. You will see the same corresponding category on the left.



Where you see the [Only registered and activated users can see links. ] and the funny phone [Only registered and activated users can see links. ], replace that with your mobile device number.



Now, for the MMS:



Make sure you follow close attention to these settings. Remember sometimes when you activate the handset, the settings will revert. That is fine, just go back and adjust them back to the Cricket settings.

You now have an ENV3 fully flashed to Cricket service. Enjoy