spc reads

[penguinfan2001]

On certain SCP-XXXX, (let's just say you've tried the memory locations without any luck) use CDMA Workshop v2.7.0, connect your phone and navigate to the Security tab. Under the SPC box, select "Universal, EFS Method" and you under the NVM file select "nvm/nvm/nvm_0002." If you get an EFS Read error then this method will not work. If you do not get your SPC from nvm/nvm/nvm_0002 then go down the list of all available options within the EFS method. I've only done this method a handful of times on 3200's, 3800's, and 3810's after the memory addresses have failed to retrieve the SPC. So far this procedure works about 80% of the time for me. Note: This procedure should be treated as a last-ditch effort to obtain the SPC if all else has failed. It tends to run very low success rate with the 2700's.

Due to lack of Sanyo phone I see and flash, I really would like to get this method verified by a few other people. Thanks.

[cricketmodder]

Verified, I actually use this method first because it is the quickest to check the 4 or so locations in the efs before i move onto the spc reads, another method is if you have exhausted all other options is to go to the memory tab in the latest cdma workshop and click read memory, and you should see a few items appearing in the log below like
unable to read
read 1200-1880
unable to read
read 4000-4a00

etc

so now to get the spc you have ranges, you will need to read the second readable range that is listed in cdma workshop so you would need to go back to security, spc nv read method and the address would be 4000-4a00
sometimes this is a huge memory address and can take awhile but it will retrieve the spc.

[bawanyh]

Does any1 have the SPC address for Sanyo 6760(Incognito)?

Thanks

[thephoneguy913]

Im looking for the same address too....PLEASE.

[bawanyh]

never mind I got it just use cdma WS and choose universal ram method and in custom put start add: 0363 and end add:0365 and read it. It will give you the SPC. It worked for me.

[Zacholley]

how come my cdma workshop wont let me input a end #?? i can put in like 01de in the first box but the 2nd box is greyed out and says 0000 and i keep getting this error
process is stopped phone does not answer