kyocera hydro from boost mobile msl

**mobulls** · 05-13-2014, 01:27 AM

Anyone figure out how to enable port on kyocera hydro
I have figure it the msl but i cannot connect to dfs/qpst of cdma workshop. any suggestions

**rich hathaway** · 05-13-2014, 10:32 AM

its in this post,the phone as modem app needs to be ported over to your model,you can get it from the cricket or i think the sprint one has it also,your boost phone will have it so you need them both to compare and write the correct values from the cricket/spr one to yours and then reload and reset that apk as system,also it is not called "phoneasmodem.APK"but is only injected into another .apk i dont remember which one it is in,i will try to look thru my notes when i return to my office and update this so you guys will know where to look,but its not hard to find,i found it.

**mobulls** · 05-14-2014, 12:22 AM

Can u please enlighten us on how u found it ?

**rich hathaway** · 05-14-2014, 10:53 AM

Its simple,I looked.
You will need a tool to open/edit both apk and jar files,look for diagcommands.jar in the frameworks folder and also the modem files and hiddenlibrary files there,probly named hiddenlib.jar but dont remember for sure and then on the /system/app side look at the corresponding folders, names will be a bit different but you will see them,look thru them and compare with a cricket or sprints apps and edit accordingly then be sure to set as sys app when you re-inject,and since reocovery is wack for those 2 phones you may go thru a phone or 2 to get the outcome you want if your not careful.but in any case be sure to save the original dump in case it can help you out if you mess up.
good luck.
I will tell you this,If you are patient there will probly be a solution coming soon,I sent my files/dumps over to another high level tech/friend who requested them and who is going to finish this project in the coming days.

**rich hathaway** · 05-15-2014, 06:35 PM

A quick update,I got the Phone as Modem app ported over to the boost phone today.see below.

[Only registered and activated users can see links. ]

unfortunately thats not all thats required to enable the data port,the other tech i am working with disabled the msl requirement for the ##diag# menu but when i tried that today it kills function for that menu.anyway a little progress is being made in our spare time.