Part 1 A new tool to fully flash iphone4,4s,ipad,ipad2,ipad3 to any cdma carrier

[lolopez999]

Glad to see you up and running id rather invest local than overseas thnx for the hard work my respects

[rotorpilot]

Ok,
my situation is this.
I got all the way to write the prl.
after that it says to hit disconnect for changes to take place.
I do that and then my phone goes to: searching - no service - iphone is not activated.

update:
after diconnecting iphone from tool it says i need to activae my iphone.
then it goes to searching...no service...
then it brings up 2 bars of resception and the circle for cell data.
what am i leaving out?

[Joe Green]

Ive got a issue after writing prl to phone, it keeps searching for service

[captainkirks]

I found out the prl makes a big different. I am using the 42900 aws, even though I am in a non aws market. It fix most of trouble that have been posted. Also got easyflashstudio to work. Found out it best to do a hard wipe and start from scratch. The service did take about 10 minutes to get a strong solid signal.

[Joe Green]

I figured it out

[rotorpilot]

well, I did a power cycle on my iphone and now its back to Metropcs with the cellular data circle on the top banner. This circle changes from a circle to a 3G symbol. but when I go to safari it says: could not activate cellular data network.
any ideas?