Droid 2 won't connect to cdma ws

[thesmitty68521]

I have done a few of these Droids and never had this problem. I connect to the HW virtual serial port and then open CDMA WS to that port and carry on.

This time it won't recognize the phone. For the Droid 2, I thought you just held down the T while booting up the phone to get it into Modem mode to be read by cdma ws.

Any suggestions?

[tonasoledad]

bro use the same as motorola x just put the phone on pc mode

[thesmitty68521]

So, you don't even have to use the T while turning on? Hmmm. I will give that a try

[cancell]

Back from the dead with a new problem:

I am flashing a D2 and I got it to connect once with HW virtual serial port. I then used CDMA W to change most everything, but I forgot to Re-write the NV items. Now I can't get the darn thing to create a port again. I have rebooted both the phone, and the comp. I have fiddled with the HW-VSP settings and currently have the NVT box unchecked (it never has been). then belowI have the following boxes checked: Log files enabled, Connect to device, even if VSP port is closed, Use ping..., and reset vsp port driver.....

what am I missing?! yaaakkkkkk...I have been at this for hours.......

On a side note, I finished my first full flash for an andriod yesterday, and It feels freaking awesome to have learned so much! thanks again to Gurus for all the info!

[tonasoledad]

the happen to me as well bro i just restar my pc ore try a othere pc
but as u see on the HW virtual just change the to a diffren port
for ex if port 3 will not creat chose port 4 and try and see if it works
make sure u have ur phone on pc mode and debu

[cancell]

Now I am working on 2 differnt phones, each with a similar problem.

Droid 2: would connect to HW virt. port but won't show up in the QPST port list

DROID 3: connected, shows up in QPST as enabled yet when I try to open service programming, It errors out and gives the MSG: Online connection error, unspecified error. then i get this list in HW virt. port
8/24/2011 10:31:04 PM : Virtual port baudrate set 38400 Bd
8/24/2011 10:31:04 PM : Virtual port control options set 8N1
8/24/2011 10:31:04 PM : Virtual port handshake set NONE

and the RX and TX bytes are going crazy like something is communicating or at least trying to.

any ideas on what I have going on? On a bright note I have figured out how to get my APN files to the phones and have been able to do most everything else in CDMA W. I just need QPST to see the Mip settings to make sure everything took.

I have been at this for 9 hrs and I think I will sleep on it for now....Thanks for all the help!

[shoegum]

ya just hold the camera button and power it will boot in diag mode, just like droidx. did one today.