Samsung SCH-LC11 Flash HELP me... please...

[Radigan]

Hi all,

I am in need of help, I have a Samsung SCH-LC11 and I am trying to use it with CDMA Workshop, and/or DFS. I have been trying for a little while now and I get this same error every time. What I see is the port it is connected to is busy and the program cannot connect to the device. Please help any1.

Thank you
-T

[JaiFar1996]

I believe for this one you have to load a flashable firmware or modem to get a good status port

[cosminch]

in order to see device in diag mode you should type in browser as follows
[Only registered and activated users can see links] and then a page will be open with a USB option like ENABLE or DISABLE. Just click on Apply and after that reconnect the device with usb port
Now, the DFS should see the device if you have the drivers for QUALCOM MDM 9600 installed (device chipset)

[bakkory]

Can you please send us the link to download QUALCOM MDM 9600 drivers after I changed enabled the DIAG mode the modem need a drivers

[aislecom]

We have a bunch of LC11 we are tyring to flash to our CDMA / LTE network. I am willing to pay for some help with this.

Dave

[rich hathaway]

I will try to help you some, why dont you pm me your skype info if you have one so we can chat about it

[JaiFar1996]

Just look at the thread right below named "How to Flash LC11 with custom drivers | RH ([Only registered and activated users can see links]). Rich's custom drivers are in there for 32 and 64 bit. I have seen them work for windows 7 64bit, windows 8 64 bit, and windows 8.1 64 bit

[TheTechDude]

You have absolutely no idea how incredibly helpful that was, thank you so much!

[rich hathaway]

:) not many peeps messing with these old cdma phones anymore.