First make sure the SPC is set to whatever your d__or is and not 000000. Also note the ESN doesn't matter, it can be 12345678901 for all that matters as EVDO does not validate against the ESN.
Next, I suggest using QPST 2.7 (323).
Use QPST to connect to the device and send the SPC, then goto M.IP.
-Active User: 1
-Mobile IP Behavior: MOB IP ONLY
-Initial Registration Retry: 2000ms
-RFC2002bis: UNCHECKED
-Re-register only if traffic since last RRQ: CHECKED
-Registration Retries: 2
-Pre-lifetime-expiry: 30
Make sure you have M.IP Profile 0 and 1 in the preview.
Profile 0 should have the username (NAI) as [Only registered and activated users can see links. ] with _HEX_ being the HEX ESN or MEID of the d__or.
-Check ENTER TEXT string for HA Shared Secret, enter "secret", without the quotes.
-Check ENTER HEX string for AAA Shared Secret, and paste the 32bit value you recovered from NV ITEM 1192 starting AFTER 10, ending before 00. It will be a total of 32 characters (remove spaces).
-Make sure Profile IS Enabled
-Make sure the Reverse Tunneling Preferred box IS checked on.
-Make sure MN-HA SPI and MN-AAA SPI is set to 4D2
-Make sure HOME Address is set to 0.0.0.0
-Make sure Primary HA Address is set to 68.28.15.12
-Make sure Secondary HA Address is set to 68.28.31.12
-Click OK.
Profile 1 should have the account username (NAI) as [Only registered and activated users can see links. ]
-Check ENTER TEXT string for HA Shared Secret and enter "secret" without the quotes.
-Check ENTER TEXT string for AAA Shared Secret and enter your 6 digit AAA password from your d__or phone.
-Make sure Profile IS Enabled
-Make sure the Reverse Tunneling Preferred box IS checked on.
-Make sure MN-HA SPI and MN-AAA SPI is set to 4D2
-Make sure HOME Address is set to 0.0.0.0
-Make sure Primary HA Address is set to 255.255.255.255
-Make sure Secondary HA Address is set to 68.28.89.76
-----
Click the PPP Config tab.
-Select Rm tab
-Leave everything the same except IPCP Compression, set this to IGNORE.
-Select Um tab
-Set IPCP Compression, to IGNORE
-Set the Primary and Secondary DNS to 0.0.0.0
-UNCHECK Optimized Dormant Handoff
-User ID must be blank
-Uncheck Req PW enc
-Select AN tab
-Leave everything the same except for:
-Set IPCP Compression, to IGNORE
-Set USER ID to Profile 0 NAI (username) [Only registered and activated users can see links. ]
Click "Write To Phone"
-------------------------------------
Now, I'm sure there's a step or two I've forgotten or included but isn't required... but this should help.
Bookmarks